If your Sky system was installed professionally, your Sky remote control should have been setup to work with your TV as well.

If your Sky remote control is not correctly operating your television, complete the following steps:

1. Turn your tv on.
   
2. Press tv on your Sky remote control.
   
3. Hold down the select and the red button together for about two seconds, until the red light on the Sky remote control blinks twice.
   
4. Press tv on your Sky remote again.
   
5. Key in the four digit code for your brand of TV. The light on the remote control blinks twice.
   
   If the light blinks once only, recheck the code for your brand of TV and start again at Step 1.
   
6. Press the on/off button on your sky remote control.
   
   If your TV switches off, press select. The light on the Sky remote control blinks twice.
   
   If your TV does not switch off, press tv, then press the on/off button. Repeat this (press tv, then on/off) until your TV turns off, then press select.
   

   If the light on your Sky remote control blinks three times, your Sky digibox has checked all the possible settings for the code you used. Check that you have the right 4 digit code and start again at Step 1.

7. Turn your TV back on again then press tv guide.
   
   If you see the TV Guide screen, the remote control setup process is complete.
   
   If you did not see the TV Guide screen, you must complete the following steps.
   
8. Press tv on your Sky remote control.
   
9. Hold down select and the green button together for about two seconds, until the red light on the Sky remote control blinks twice.
   
10. Key in the number of the channel on your TV that you use for watching satellite TV.
    
11. Press select on your Sky remote control. The red light blinks twice. The remote control setup process is complete.
    

    If after trying this, you still have problems, call your broadcaster's helpdesk. For your broadcaster's helpdesk number, select the Telephone Numbers option from the Services screen.